2.2 Scanning Documents of Different Widths

2.2Scanning Documents of Different Widths

When you scan documents of different widths at one time from the ADF, some documents that are small in paper size may be skewed or may not be fed into the scanner. It is recommended that only documents of the same width be scanned at one time.

In the case where you have to scan documents of different widths together, scan them, following the procedure below.

1.To prevent images from skewing, select [Automatic Page Size Detection] from the [Automatic Size and Skew Detection] drop-down list. (For details, refer to "2.9 Correcting Skew" on page 71.)

2.Center all documents as shown in the figure below.

3.Place the documents on the ADF paper chute, and then adjust the side guides so that they lightly touch the widest sheets of paper.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ATTENTION

 

 

When placing the stack of documents on the scanner, make sure that all

 

 

 

 

 

 

 

 

 

documents are directly under the pick roller. Off-center documents, which

 

 

 

 

 

 

 

 

 

are not under the pick roller, cannot be fed into the scanner.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4. Scan the documents.

For information about how to scan documents, refer to section "1.5 How to Use ScandAll PRO" on page 29.

2

DOCUMENTS OF TYPES VARIOUS SCANNING

fi-5530C2 Image Scanner Operator’s Guide

 

47