Fujitsu fi-6010N Calibrating the Touch Panel, Appendix A

If some other error occurs
•	Message
ing the power off	An error has occurred. Tr
	and back on again. The administrator should
	contact the FUJITSU scanner dealer or an autho-
	rized FUJITSU scanner service provider for
	help. [alphanumeric eight digits]
•	Action
	Try the following:
	•	If the scanner does not restart automatically,
		press the [Shutdown] button on the "Login"

screen to turn the power off, and turn the power back on again to restart the scanner.

• If the error status persists after the scanner is restarted, press the [Shutdown] button on the "Login" screen, disconnect the AC cable from the scanner to turn the power off, wait for at least ten seconds, then reconnect the AC cable and try turning the power back on again. If the error status persists, contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.

17

					fi-6010N Network Scanner Getting Started
	Appendix A		Calibrating the Touch Panel
	This should be done if and when the touch panel
ent with the positions of	responses seem out of alignm				The keyboard may also be used on the
	objects on the LCD screen.			HINT	calibration screen:
	1.	Login as the administrator.			• Press the [Home] key to jump straight to
					the post-calibration test screen.
		For details, refer to "3.1 Logging in" (page 6).			• Use the arrow keys to move the "+"
					to a different calibration point. This
		⇒ The "System Settings" screen appears.
					allows a bad touch to be redone.
	2. Select the [System Settings] tab on the top				• Press the [Esc] key to stop the cali-
					bration process and return to the
		menu.			"Screen Calibration" screen.
	3. Select the [Screen Calibration] tab on the left				• Press the [Enter] key to close the
					error dialog. (Not normally needed.)
		side menu.
		⇒ The "Calibration Screen" appears.			Repeat until the test screen appears, with the fol-
	4.	Press the [Calibrate Screen] button.			lowing "Calibration" dialog box:

			6. Trace a line on the screen with your fingertip.
						⇒ A corresponding line will appear on-screen.
							If the line does not appear correctly, press the
							[Calib screen] button to return to Step 5.
							If the screen becomes cluttered, press the
							[CLR screen] button to remove all the lines.
							The [Cursor on/off] button cannot be used.
			7. When you are satisfied with the touch screen
					response, press the [Update] button.
	⇒ A blank calibration screen appears, with a red					⇒ This saves the current calibration data, com-
		"+" (adjustment mark) in the top-left corner.					pleting the calibration process, and returns you
							to the "Screen Calibration" screen.
5. Touch the "+" with your fingertip.
		After being touched, the "+" will move to
								If the calibration is not performed
		the next calibration position. Each time
				ATTENTION				carefully, or the [Enter] key is pressed
		it stops, touch it again.
								before all the calibration points have
								been touched, the following error
								message may appear:
								Parameter Error. Please input, again
								Press the [Enter] key to dismiss the
								error dialog, and perform the calibra-
								tion again, being careful to touch each
								calibration point accurately.

18