2.4Attaching the Keyboard Cover
The layout of the keyboard may differ according to the language selected for the operating environment. The layout of each keyboard cover is prepared according to language requirements. Take the keyboard cover for the
ch it to selected language out of its p
the scanner. This scanner is set up for use with an English (US) keyboard. Therefore, if the scanner is to be used with an English (US) keyboard attaching a key-
Top attachment area
Chapter 3 Setting up for Network Use
3.1 Logging in
Do not move or shake the
scanner when it is turned on. This can damage the rotating hard disk drive and cause data to be lost.
board cover is not required.
ATTENTION | Check that the power is turned off |
| before attaching the keyboard cover. |
To set up the network connection, you must login as the administrator. The user name and initial password for the administrator are as follows:
• User Name: admin
• Password: password
You can select whether or not to display |
1. Clean the surface of the keyboard.
Pay particular attention to these areas
2.Turn the keyboard cover over and remove the paper backing from the top strip of double- sided tape.
Paper backing tape
Underside
3.Align the top edge of the keyboard cover with the protruding guides, and firmly smooth the
Align and attach the
4.Flip up the keyboard cover and remove the paper backing from the bottom strip of double- sided tape.
Paper | Flip up the | |
keyboard cover | ||
backing tape | ||
|
5.Gently stretch the keyboard cover forward and smooth the
Bottom attachment area
Continue setting up the network.
1. Press the startup button.
Startup button
⇒After the system starts up, the "Language / Keyboard Selection" screen appears.
HINT | this screen again at the next start up. To |
| |
| display the screen again, for "Show this |
| message at next start up?", press the |
| [Yes] button. To not display this screen at |
| next start up, press the [No] button. |
| To change the setting back to displaying |
| this screen at the next start up, login as |
| the administrator and for "Show the |
| "Language/Keyboard Selection" screen |
| at next start up?", press the [Yes] button |
| on the "Language/Keyboard Selection" |
| screen. |
3. Press the [OK] button. |
The "Login" screen appears. |
ATTENTION
HINT
After turning the power off, wait for at least ten seconds before turning the power back on again.
If touch panel responses seem out of alignment with the positions of objects on the LCD screen, calibrate the screen.
For details, refer to "Appendix A Calibrating the Touch Panel" (page 18).
⇒ |
ATTENTION | If the language is changed in Step 2, |
the following screen appears. | |
| The message is displayed in the |
| selected language. |
2. Select a language.
Select the desired language for the operating envi- ronment. The default language is "English (US Keyboard)".
Pressing the [OK] button restarts the scanner, and the "Login" screen.
4. Enter the user name.
User name is case sensitive. Enter "admin" here.
5
6