1.5 Names and Functions of

■Removable Parts

fi-6010N Network Scanner Getting Started

Chapter 2 Setting up the Scanner

Parts

This section describes the scanner parts and their func- tions.

■Front

Startup button

ADF paper chute Side guides

Top cover

[SCAN] button

LCD touch panel Keyboard

Parts that can be removed from the scanner are displayed below.

Separate shaft and roller

Pad assembly

Pick roller

Sheet guide

ADF paper chute

2.1 Space Requirements

The following space is required to set up the scanner: Depth: 700mm (28in)

Width: 400mm (16in)

Height: 500mm (20in)

2.2 Installing the Scanner

When lifting the scanner, always

￿￿￿￿￿￿￿ hold it by the indentations on the bottom of each side to ensure a stable grip.

Holding the scanner in any other way may cause it to be dropped or damaged.

2.Connect the AC adapter connector to the scan- ner's DC inlet.

Output tray

■Rear

ADF release button

Back cover

 

To remove the back cover of the

ATTENTION

scanner, press the tabs on the cover

 

 

to unlock it, and pull out. Make sure

 

to pull the cover out straight, to pre-

 

vent the it from being damaged.

3. Connect the LAN cable to the LAN connector.

￿￿￿￿ ￿￿￿ ￿￿￿￿￿￿￿ ￿￿

￿￿￿￿￿ ￿￿￿￿ ￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿ ￿￿￿￿￿￿￿￿

Back cover

Inside the back cover

Security cable slot

LAN connector

AC adaptor connector

Press the tabs on the

right and left of the cover

and pull out.

1.Place the scanner at its installation site.

2.Attach the ADF paper chute.

Hold the ADF paper chute and insert its tabs into the corresponding slots in the scanner as shown in the following figure.

The side guides of the ADF paper chute should face up.

Tab

2.3 Connecting the Cables

1. Connect the AC cable to the AC adapter.

ATTENTION

Use only the AC adapter provided by

the manufacturer.

4. Attach the back cover.

Attach the cover with the connected AC cable and LAN cable protruding out of the lower part of the cover.

Tab

To make sure the cover is properly attached,

insert the right and left tabs at the same time.

5. Connect the other end of the LAN cable to the network hub.

6. Insert the AC cable into a power outlet.

⇒ The power is connected but the scanner is not yet ready for operation.

3

4