Fujitsu MAP3367NC/NP, MAP3147NC/NP, MAP3735NP manual Shows the Scsi functions provided with the IDD

2.2SCSI Function Specifications

Table 2.4 shows the SCSI functions provided with the IDD.

		Table 2.4		SCSI function specifications
		Item					Specification
	Single-ended type							Ο
	HVD type (High Voltage Differential)							⋅
Electrical	LVD type (Low Voltage Differential)							Ο
requirements	Single-ended type		Position where the terminating					⋅
(*1)			resistor is mounted on the PCA
	Differential type		Position where the terminating					⋅
			resistor is mounted on the PCA
	TERMPWR signal send function							Ο
Connector	68 pin P cable connector						Ο	(NP model)
	80 pin SCA2 connector						Ο	(NC model)
Data bus parity (Data bus CRC)								Ο
Bus arbitration function								Ο
Disconnection/reconnection function								Ο
	SCSI ID	16-bit SCSI						#0 to #15
Addressing							(Jumper selection)
	LUN (logical unit number)							#0 fixed
	8-bit SCSI (Single-ended type)					Ο	20 MB/s max.
Data transfer		(LVD type)				Ο	40 MB/s max.
	16-bit SCSI (Single-ended type)					Ο	40 MB/s max.
(Synchronous
						Ο	80 MB/s max.
mode)		(LVD type)
		(U160 LVD type)				Ο	160 MB/s max.
		(U320 LVD type)				Ο	320 MB/s max.
Data buffer								8 MB
Data block length (Logical data length=Physical data length) (*2)							512 to 528 bytes
							(Fixed length)
				Ο	: Provided			⋅ : Not provided

(*1) The driver mode (Single-ended or LVD) changes automatically by Diffsence signal level.

(*2) Refer to (12) of Section 1.1.

C141-E166 2-7