Fujitsu MB9B500 Series Jumpers Overview, Setting for UART On-Board Programming, 1 Jumper List

2.2 Jumpers Overview

	Jumper Name		Function		Setting
	J101-J103*1		Power selection		Short J101: select external power
					Short J102: select JTAG power
					Short J103: select USB power
	J104*2		Voltage selection		Short 1,2: 5V
					Short 2,3: 3.3V
	J-USB-		USB Host/Function	Short 1,2: USB Function
	J-USB+		selection	Short 2,3: USB Host
	J105	Mode setting		Short: Programming mode
				Open: Normal mode
	J106		Oscillator Selection		Short 1,2: when 4M oscillator is used
					Short 2,3: when 48M oscillator is used
	J107	P22 connection		Short: connect P22 (UART_TX0) with MAX3232
				Open: disconnect P22 (UART_TX0) with MAX3232
	J701	Voltage division		Short: when 5V power is used
				Open: when 3.3V power is used
Attention:			Table 2-1: Jumper List

1)Never short J101-103 at the same time! When Keil U-Link ME is used, JTAG power can not be used.

2)When Keil U-link is used, only 3.3V can be selected, never select 5V power!

2.3 Setting for UART On-Board Programming

	Part Number		Function		Setting
	UART-0		DB9 connector		Connect with PC via RS232 cable
	J106	Oscillator Selection			Open
	J105	Mode setting			short
	J107		P22 connection		short
				Table 2-2: Setting for UART On-Board Programming
2.4 Setting for USB On-Board Programming
	Part Number			Function		Setting
	USBFUNCTION			USB function connector		Connect with PC via USB cable
	J-USB-			Function/Host selection		Short 1,2
	J-USB+
	J105		Mode setting			Short
	J106			Oscillator Selection		Short 1,2
	J107		P22 connection			Open
	J701		Voltage division			Short: when 5V power is used
						Open: when 3.3V power is used
				Table 2-3: Setting for USB On-Board Programming

8