E-10
BASIC OPERATIONS
TURNING THE POWER ON AND STAND-BY
1Press
/I to the left at the bottom of the display to the ON
state.
The power lamp lights up.
2Press on the remote control.
The color of the power lamp changes from “Red” to “Green”.
3Press " – ' or ).
Select the video mode to input.
4Press when the power is ON.
The color of the power lamp changes from “Green” to “Red” and the the power turns “OFF (Stand-
by state)”.
ADJUSTING THE VOLUME
Adjusting the volume
Press 1 to increase the volume.
Press 2 to reduce the volume.
* Note that the volume level remains stored even when you
turn OFF the power.
Muting the audio
Press -.
The audio is removed.
Press again to restore the audio to the original level.
The mute mode can also be released by pressing the volume buttons.
VIDEO INPUT M ODE
1Press "-' to select the input
mode.
You can select from VIDEO1 mode to VIDEO6
mode.
The video modes corresponding to each input
terminal are as follows.
•VIDEO1: Video
• VIDEO2: S-video
• VIDEO3: Component video
• VIDEO4: Component video
• VIDEO5: HDMI
• VIDEO6: HDMI
* For selection of the input terminal, see “SETTING THE INPUT TERMINALS” on P.E-24.
*You can also use the buttons
on the display’s control
panel to perform these steps.
Note
• Functions may not be ava ilable with some models and some device options.
*You can also use the buttons
on the display’s control
panel to perform these steps.
When the volume adjustment button is
pressed
*You can also use the buttons
on the display’s control
panel to perform these steps.
Video1 mode
7527_E.book 10 ページ ２００６年９月５日 火曜日 午後９時３５分