If the around the pick roller is dirty by paper -powder, it may cause a scanning error. Please remove the dirt using a dry cloth with dollop of Cleaner F1.

*Don't use water, mild detergent or air-spray.

7.Remove the Pick roller from the shaft.Pull out the shaft from the Pick roller while lifting up its tab.

Tab

Shaft

Pick roller

If you push up the pick roller tab using your fingernail, your fingernail may be hurt or get chipped. If you cannot push it up successfully with your fingernail, use a paper clip to push up the pick roller tab.

1

2

8.Attach the new Pick roller to the shaft.Insert the shaft aligning the protrusion with the slot on the new Pick roller.

Pick roller

Slot

ShaftProtrusion

9.Install the Pick roller with its shaft into the bushing and set the shaft to the slot while lowering it.

Bushing

Shaft

Pick roller

22

10.Fix the Pick roller bushing (left) by rotating it in the direction of the arrow.

Pick roller

Pick roller

 

bushing

Shaft

Make sure that the Pick roller is completely attached and correctly installed. Otherwise, document jams or other feeding errors may occur.

11.Attach the sheet guide to the scanner.

While holding the handle on the sheet guide, set the sheet guide into the scanner.

Sheet guide

Handle

 

Craw

You should hear the sheet guide click when it returns to its original position.12. Close the ADF.

ADF cover

You should hear the ADF cover click when it returns to its original position.13. Turn on the scanner.

ScanSnap Manager icon changes from to S .