L i f e B o o k S 7 0 0 0 N o t e b o o k

Problem

Possible Cause

Possible Solutions

 

 

 

 

 

 

Memory Problems

 

 

 

 

 

Your Power On screen does

Your memory upgrade module

Remove and re-install your memory upgrade

not show the correct

is not properly installed.

module. (See Memory Upgrade Module on page 43

amount of installed

 

for more information)

memory.

 

 

You have a memory failure.

Check for Power On Self Test (POST) messages.

 

 

 

(See Power On Self Test Messages on page 57 for more

 

 

information)

 

 

 

Modem Problems

 

 

 

 

 

Messages about modem

Messages about modem

See your application software documentation for

operation.

operation are generated by

additional information.

 

whichever modem application

 

 

is in use.

 

 

 

 

USB Device Problems

 

 

 

 

 

You have installed a USB

The device is not properly

Remove and re-install the device. (See Device Ports

device, but your LifeBook

installed.

on page 45 for more information)

notebook does not recog-

 

 

The device may have been

Close the application and restart your notebook.

nize the device, or the

installed while an application

 

device does not seem to

 

was running, so your notebook

 

work properly.

 

is not aware of its installation.

 

 

 

 

 

 

 

Your device may not have the

See your software documentation and activate the

 

correct software driver active.

correct driver.

 

 

 

 

You may have the wrong I/O

See your device documentation and software docu-

 

address selected for your

mentation to determine the required I/O address.

 

device.

Change the settings in the BIOS setup utility. (See

 

 

BIOS Setup Utility on page 29 for more information)

 

 

 

 

Your device and another device

Check all I/O addresses located within the BIOS

 

are assigned the same I/O

setup utility and any other installed hardware or

 

address.

software to make sure there are no duplications.

 

 

 

 

Parallel port is set to output

Check parallel port setting in the BIOS and set to

 

only.

bi-directional or ECP.

 

 

 

ExpressCard Problems

 

 

 

 

 

A card inserted in the

The card is not properly

Remove and re-install the card. (See ExpressCards™

ExpressCard slot does not

installed.

on page 42 for more information)

work or is locking up the

 

 

The card may have been

Close the application and restart your notebook.

system.

installed while an application

 

 

 

 

was running, so your notebook

 

 

is not aware of its installation.

 

 

 

 

 

Your software may not have

See your software documentation and activate the

 

the correct software driver

correct driver via the Device Manager

 

active.

 

 

 

 

 

You may have the wrong I/O

See your PC Card/ExpressCard documentation to

 

address selected for your card

determine the required I/O address. Change the

 

device.

settings in the Device Manager.

 

 

 

52

Page 62
Image 62
Fujitsu S7211 manual Memory Problems, Amount of installed, Modem Problems, USB Device Problems, ExpressCard Problems