SPARC Enterprise M8000/M9000 Servers Product Notes 27
Upgrading From XCP104x to XCP 1050 or Later The following steps describe the case of upgrading to XCP1060.
Note – By upgrading to XCP 1050 or later, XSCFU_B#1 will start working. When
your system is using RCI network, XSCFU_B#1 needs proper configuration of
cabling or termination to setup RCI network, properly.
For further information, please contact a certified service engineer.
Note – Do not access the XSCF units via the "Takeover IP address".
Note – LAN connections are disconnected when the XSCF resets. It is recommended
to use the XSCF serial connection to simplify the XCP upgrade procedure.
1. Log in to the XSCF#0 on an account with platform administrative privileges.
2. Verify that there are no faulted or deconfigured components by using the
showstatus(8) command.
The showstatus(8) prompt will return if there are no failures found in the System
Initialization. If anything is listed, contact a certified service engineer. before
proceeding.
Note – Take information with using BUI or snapshot(8) command. This will be
help in case any problem occurred in this procedure.
3. Power off all domains.
4. Confirm that all domains are stopped:
5. Move the key position on the operator panel from Locked to Service.
XSCF> showstatus
XSCF> poweroff -a
XSCF> showlogs power