FUNAI CIWP4206 A owner manual Miscellaneous

Symptom	Remedy
Ghosts in picture	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and
	connection.
	• Electrical interference from nearby appliances may affect picture
	quality.
	• View other TV channels. The problem might be limited to the
	broadcasting station.
Bars on screen	• When the outside antenna is used, check the wire condition and
	connection.
	• Electrical interference from nearby appliances may affect picture
	quality.
Picture rolls vertically	• When the outside antenna is used, check the wire condition and
	connection.
	• Electrical interference from nearby appliances may affect picture
	quality.
	• View other TV channels. The problem might be limited to the
	broadcasting station.
Different color marks on screen	• Move your TV away from nearby electric appliances. Turn off the
	power and wait 30 minutes before turning it back on.
	• View other TV channels. The problem might be limited to the
	broadcasting station.
Poor reception on some channels	• Check the antenna or cable connection to the main unit.
	• When the outside antenna is used, check the wire condition and
	connection.
	• Electrical interference from nearby appliances may affect picture
	quality.
	• View other TV channels. The problem might be limited to the
	broadcasting station.
Picture OK, sound poor	• Electrical interference from nearby appliances may affect picture
	quality.
	• View other TV channels. The problem might be limited to the
	broadcasting station.

MISCELLANEOUS

Burn-in on screen	• Do not continuously display images such as video games, com-
	puter graphics, stock market quotations or other fixed patterns.
	Those images may cause screen burn-in.
	If burn-in occurs, display a movie or TV show to reduce the
	problem.
	These images can cause permanent damage to your screen.
	Burn-in caused by misuse is not covered by your warranty.
No reception of digital signals	• Make sure Autoscan has been completed (Refer to “AUTOSCAN” on
	page 14). Autoscan must be completed when you set up your TV for
	the first time or move it to a location where previously unavailable
	channels are broadcast.
	• The selected channel may not be broadcasting.
	• When Autoscan is interrupted, some channels will not be
	received. Make sure to complete Autoscan in the setup screen.
Channel changes automatically	• Many digital channels have alternate channel numbers. TV changes the
	numbers automatically to the ones signifying the broadcasting stations.
	These are the numbers used for analog broadcasts.
Remote Control doesn’t work	• Check the antenna or cable connection to the main unit.
	• Check the batteries of the remote control.
	• Check if there is an obstacle between the sensor and the
	remote control.
	• Test the signal output. If OK, there might be remote sensor trou-
	ble. (Refer to “IR SIGNAL CHECK” on page 36.)

33

EN