•IGNITION NOISE:
Black spots or horizontal streaks may appear, picture may flutter or drift. Usually caused by interference from automobile ignition systems, neon lamps, electrical drills and other electrical appliances.
•GHOSTS:
Ghosts are caused by the television signal following two paths. One is the direct path and the other is reflected from tall buildings, hills or some other objects. Changing the direction or position of the antenna may improve reception. Ghosting may also be caused by defects in the antenna system such as unshielded leads or connecting several sets to the same antenna without using multiple antenna couplers.
Ghosting occurring when the TV is connected to a cable TV system may indicate a bad cable wire or loose connection. Confirm that the cable wire is properly connected.
•SNOW:
If your receiver is located in the fringe area of a television station where the signal is weak, your picture may be marred by the appearance of small dots. When the signal is extremely weak, it may be necessary to install a special antenna to improve the picture.
Snowing occurring when the TV is connected to a cable TV system may indicate a bad cable wire or loose connection. Confirm that the cable wire is properly connected.
•RADIO FREQUENCY INTERFERENCE:
The interference produces moving ripples or diagonal streaks, and in some cases, causes loss of contrast in the picture.
•PREVENTION OF AN OBSTACLE TO RADIO RECEIVERS:
This TV has been designed pursuant to the FCC class B Rules. This is to prevent a problem to Radio receivers. lf this TV causes a problem to Radio receivers, then take the following steps:
-Keep the monitor away from Radio.
-Adjust Radio antennas in order for the TV not to receive interference.
-The antenna cable of Radio should be kept away from the TV.
-Use a coaxial cable for antenna.
You can check if this TV influences Radio receivers by turning off all other equipment other than the TV.
If you find a problem receiving Radio when using the TV, check the instructions mentioned above.
Vertical stripes appear, | •The plasma display panel is lighting the phosphors by the discharge of |
depending on the screen | internal radiation. Depending on the screen contents, in rare cases this |
contents. | may cause vertical stripes to appear because of failure to light. Please |
| note that this is not a malfunction. |
MISCELLANEOUS
35
EN
