FUNAI CIWP4206 A owner manual Initial Settings Initial Setup, Autoscan will start automatically

INITIAL SETTINGS

INITIAL SETUP

This section will guide you through your TV’s initial set up which includes selecting a language for your on-screen menu and AUTOSCAN, which automati- cally scans and memorizes viewable channels.

POWER	SLEEP	INPUT
		SELECT

4Select source of ANT. IN jack using [K/L], press [ENTER].

InitialI i i l Setup

Make sure the antenna is connected to "ANT IN" jack.			Air
Select the destination of "ANT IN" jack.			Cable
Air
Cable	Or
	ANT IN
Select	BACK	Back	SETUP
	ENTER Enter		Exit

1	2	3
4	5	6
		AUDIO
7	8	9
		STILL
-	0
SETUP		SCREEN
		MODE
		ENTER
BACK		INFO

5Autoscan will start automatically.

InitialI i i l Setup

Now the system is scanning for channels,please wait.

5%

Analog channels	1ch
Digital channels	0ch
	SETUP

Exit

/ INITIAL SETTINGS

1After making all the necessary connections, turn on your TV.

2Press [POWER]. Initial Setup menu will appear.

•This operation may take a few moments.

•If Initial Setup menu does not appear, press and hold [ENTER] for 3 seconds, initial setup will appear then proceed to step 3.

•If initial set up has already been completed, refer to “LANGUAGE SELECTION” on page 17.

3When you first turn on your TV, the following screen is displayed. Use [K/L] to select the on-screen menu language from the choices on the right side of the screen.

InitialI i i l Setup

Select the language for setup display.		English
Elija idioma de preparación.		Español
Sélectionner langue écran config.		Français
Select	ENTER Enter	SETUP
		Exit

The Antenna Confirmation menu on step 4 will be displayed in the selected language after you press [ENTER].

•When scanning has completed, the lowest memorized channel will be displayed.

NOTES:

•If you do not operate your TV for more than 45 seconds dur- ing the initial setup, the message boxes start to move to the lower left-hand corner of the screen to prevent burn-in. This is to save your screen from burn-in. Press any key except [POWER] to cancel it.

•The initial Autoscan function can be executed for either “Air” or “Cable” only once. When you change the connection (Air/Cable), set the “Autoscan” again. (Refer to page 14.)

•If you connect a cable system directly, contact the CATV installer.

•When the scanning is not completed, Helpful Hint will be displayed every time you turn on the power. If you have previously registered channels when this screen appears you can select a channel with [the Number buttons].

2-0

No channel is registered.

Press and hold "ENTER" key for 3 seconds.

Contact support hotline provided on manual or back of unit.

Sin canal registrado.

Mantenga oprimida la tecla "ENTER" durante 3 segundos.

Llame teléfono de apoyo en manual o atrás de TV.

Pas de chaîne consign.

Maintenir la touche "ENTER" pressée 3 secondes.

Contacter numero d'urgence dans manuel ou arrière appareil.

•Toll free customer support line can be found on the cover of this manual.

PREPARATION FOR USE

13

EN