FUNAI FDRV90E Functional overview cont’d, VCR/DVD recorder Switching, 60˚ Remote control

Before you start

Functional overview (cont’d)

Installing batteries in the remote control Using a remote control

Before you start

Install two AA batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1 2 3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together, although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery com- partment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction rules that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disas- semble batteries.

VCR/DVD recorder Switching

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

•Use within the operating range and angle as shown.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall off in the operating range of the remote control.

Within about 23feet (7m)

60˚

Remote control

Connections Getting started Recording Playing discs Editing

Because this product is a combination of a VCR and a DVD recorder, you must select first which com- ponent you wish to operate with the SELECT button.

Changing the

VCR MODE

Press the VCR button on the remote control. (Verify that the VCR SELECT indicator is lit.)

DVD MODE

Press the DVD button on the remote control. (Verify that the DVD SELECT indicator is lit.)

Note

•Pressing only the SELECT button on the front panel DOES NOT switch the mode of the remote control.You MUST select the correct mode on the remote control.

•Pressing the SETUP or the VCR Plus+ but- ton switches the unit to the DVD mode.

SELECT button

SELECT

VCR	DVD	DVD button
		VCR button

DVD SELECT indicator

VCR SELECT indicator

POWER				OPEN/
				CLOSE
VCR Plus+		.@/:	ABC	DEF
SEARCH		GHI	JKL	MNO
MODE
CM SKIP	PQRS		TUV	WXYZ
ZOOM			SPACE
CLEAR/		REC	AUDIO	DISPLAY
C.RESET	MONITOR
MENU/LIST				TOP MENU
RETURN				SETUP
VCR		VIDEO/TV		DVD
SLOW		REC
		SPEED REC/OTR
SKIP				CH
	STOP		PLAY
REW				FWD
		PAUSE

SETUP menu VCR functions Others Español Français

9