FUNAI LD195EMX owner manual 5Still Mode, 5Switching Each Input Mode, 5Switching Audio Mode

Español Français English

5Still Mode

You can pause the image shown on the TV screen.

Press [PAUSE F] to pause the image shown on the TV screen.

Still

•The sound output will not be paused.

•If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted.

•The still function will be released after 5 minutes.

To cancel still mode, press any button except [POWER].

5Switching Each Input Mode

You can easily switch with the remote control to the DTV (ATSC) and TV (NTSC) or to access external devices when they are connected to the unit.

Press [INPUT SELECT] or [CH K] repeatedly to cycle through the input modes.

DTV/TV channel

Video

Component

or

HDMI1

HDMI2

PC

•Pressing [CHL] reverses the direction of the input modes.

5Switching Audio Mode							INTRODUCTION
This section describes how to switch the audio in the analog mode and how
to switch the audio language in the digital mode.
	TV
	Press [AUDIO	] to display the currently selected					PREPARATION
	audio mode. While receiving an MTS broadcast,
	press repeatedly to cycle through the available audio
	channel.
				11
				SAP / STEREO
	When all audio are available						WATCHING
	SAP / STEREO					SAP / MONO
			SAP / STEREO				TV
	When stereo and monaural audio are available
	MONO / STEREO					MONO / STEREO
							OPTIONAL
	When SAP and monaural audio are available
	SAP / MONO					SAP / MONO	SETTING
			MONO
	When only monaural audio is available
			(cannot be switched)
	STEREO	OPERATING
			: Outputs stereo-audio
	SAP	: Outputs second audio program
	MONO	: Outputs mono-audio
DTV							DVD
1 Press [AUDIO		] to display the currently selected
							DVD
	language and the number of available languages.
				11-1			SETTING
					English 1/3
2 Press [AUDIO		] repeatedly to cycle through the
							TROUBLESHOOTING
	available audio languages.
	• Available languages differ depending on the
	broadcast. “Other” is displayed when the audio
	language cannot be acquired, or the acquired						INFORMATION
	languages are other than English, Spanish or French.
	Note:
	• [AUDIO ] does not control external audio devices.
	• The information display will automatically disappear in a
	few seconds.

17

EN