2 Align the 2 stand hooks with the two hooks under the bottom of the main unit (shown by arrow ), then slide the stand in the direction as shown by arrow until it stops and the 4 mounting holes are aligned. Make sure not to put the AC power cord between the stand and the unit.

INTRODUCTION

5Supplied Accessories

owner’s manual

quick start guide

remote control

batteries

Phillips pan screw for

(1EMN24759)

(1EMN24760)

(NF607UD)

(AA x 2)

attaching the stand x 3

 

 

 

 

 

 

 

 

 

 

 

(FPH34120)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

AA

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

AA

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

5Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:

TV FUNCTIONS

DVD FUNCTIONS

TV : Analog TV operation

DTV : Digital TV operation

If neither symbol appears under the function heading, operation is applicable to both.

DVD : Playback of DVD-video

CD : Playback of audio CD

If neither symbol appears under the function heading, operation is applicable to both.

5Attaching the Stand

You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper direction.

1 Spread a thick and soft cloth over a

3 Drive Phillips pan screws in the 3

table as shown below.

threaded holes at the bottom of the

Place the main unit face down onto it.

stand until they are tight.

Make sure not to damage the screen.

 



front

side

 

To remove the stand from this unit

Unscrew the Phillips pan screws indicated by above

”screw holes. After the screws are removed pull the stand up toward the rear of the unit. Be careful not to drop the stand when you remove it.

Œ

Žscrew holes

Œ

Note:

When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.

Make sure to use a table which can support the weight of this unit and is larger than this unit.

Make sure the table is in a stable location.

5Tilt Stand

-2.5°

 

You can adjust the stand to change the angle of the unit (-2.5° to 10°).

10°

4

EN

Page 4
Image 4
FUNAI LD195EMX Introduction, 5Supplied Accessories, 5Symbols Used in this Manual, 5Attaching the Stand, 5Tilt Stand