FUNAI MWR10D6 owner manual Timer Recording cont’d, Timer REC indicator will be off

Recording

Timer Recording (cont’d)

Checking, canceling, or correcting the timer programming information

1

1

Press [STANDBY-ON ].

TIMER REC indicator will be off.

2

Press [TIMER PROG.].

Timer Programming list will appear.

		Timer Programming
		Date	Start	End	CH	Mode
	1.	JAN/01	12:57AM	1:57AM	CH 8	HQ
	2.	---
	3.	---
3

Check the information on the list you will need.

4

To clear the timer programming: Using [K / L], select the program. Press [CLEAR].

To correct the timer program- ming:

Using [K / L], select your desired program. Press [OK].

Next, correct the timer programming by using [K / L / { / B]. Finally, press [OK] again.

5

Press [TIMER PROG.] to exit.

6

4

2

5

6

Press [STANDBY-ON ] to return to the timer standby mode.

To stop the Timer Recording in process

Press [STOP C] on the front panel of the unit. [STOP C] on the remote control is not effective.

If the timer program did not complete correctly, the error number appears in the Timer Programming list.

Note

•Press [TIMER PROG.] to check the timer programming in process.

When the Timer Recording is proceeding, that program will be highlighted with red. In this case, you cannot select any other program.

Timer Programming

	Date	Start	End	CH	Mode
* JAN/01		12:57AM	1:57AM	CH 8	E22
2.	---
3.	---
4.	---
5.	---
6.	---
7.	---
8.	---

Press [CLEAR] to erase the selected program.

Each error number means:

E1-22	Recording error other than	E41	Power failed
E37-39	below
E23-24	Unrecordable disc	E42	No disc when recording
E25-26	Copy prohibited program
E29	Disc protected	E43	Already 49 titles recorded
E30	Disc full	E44	Already 254 chapters
E34	No space for Control		recorded

information

E35	PCA full	E45
E36	Already finalized Video	E46
	format disc
E40	Some portion has not
	been recorded because
	of program overlapping.
	Recording did not start at
	the start time.

Copy prohibited program

It is impossible to record additionally on a disc recorded by other units when setting Replace Disc Menu to OFF.

•E27,E28,E31,E32 and E33 are not displayed.

•A program with the error number is grayed and asterisked in the Timer Programming list.

•Once the Timer Programming list with error line(s) is displayed, or after canceling and setting again the timer standby mode, the program line(s) with error will be cleared.

30EN