FUNAI ZV457MG9 A owner manual VCR Functions, One-touch Timer Recording OTR, Press Stop C

VCR FUNCTIONS

One-touch Timer Recording (OTR) Index Search

Introduction

This feature allows you to set the recording length simply by pressing [REC] on the remote control.

Press [VCR] first.

1)Insert a recordable tape with an erase-protection tab intact.

2)Select the recording mode using [REC MODE]. (Refer to “Note for DVD to VCR duplication” on page 52 and “Recording” on page 94.)

3)Select stereo or SAP. Refer to page 35.

4)Select the desired channel to record using [CHANNEL / ] or [the Number buttons].

5)Press [REC] to begin the one-touch timer recording. You can select a fixed recording time by pressing [REC] repeatedly.

(0:30) (1:00) (Normal recording)

(8:00) (7:30)

When the one-touch timer recording is finished, the unit will turn to the standby mode automatically.

To change the recording length during the one- touch timer recording:

Press [REC] repeatedly until the desired length appear.

To cancel the one-touch timer recording within the specified time:

Press [STOP C].

Note

•The remaining recording time will be displayed on the front panel display during one-touch timer recording. Press [DISPLAY] to see it on the TV screen.

•You cannot pause the one-touch timer recording.

•If VCR one-touch timer recording is completed during DVD playback or recording, the VCR will be in stop mode and the DVD keeps the current mode.

•Unlike a timer recording, you can perform the following operations during the one-touch timer recording.

-Turning the power to the standby mode to stop one- touch timer recording.

-Using [REC] or [STOP C] on the remote control.

•When the one-touch timer recording is finished and the power is in the standby mode, the unit will switch to the timer standby mode automatically if a timer recording has been programmed. Press [TIMER SET] to cancel the timer standby mode for using the unit continuously.

•This function is available only when the unit is connected by the VIDEO OUT jack.

An index mark will be assigned at the beginning of each recording you make. You may skip to a specific marked point by following the steps below.

Press [VCR] first.

1)Press [SEARCH] so that “INDEX SEARCH” menu appears.

2)Using [the Number buttons], enter the number of recordings you wish to skip within 30 seconds.

INDEX SEARCH 03

3)Press [E], [D] to start index search.

If you want to go in the forward direction, press [D]. If you want to go in the reverse direction, press [E].

After index search, the VCR will play back the cassette tape automatically.

CURRENT PROGRAM
Beginning	End
of tape	of tape

Pro.1 Pro.2 Pro.3 Pro.4 Pro.5

02 01 01 02 03

INDEX MARK

Note

•You can make the index mark up to 20.

•This function is available only when the unit is connected by the VIDEO OUT jack.

EN 95

Connections Basic Setup Recording Playback Editing Function Setup VCR Functions Others

Español