Furuno FAR-2157 installation manual TB801 PCB 03P9436 Cable gland for signal cable RW-9600

4.In the order shown in the figure below, pass the gland nut, flat washers (3 pcs.) and gasket onto the signal cable.

Armor Gasket Signal cable

Flat washer Flat washer Gland nut

(2)(1)

5.As shown in the figure below, fold back the armor onto flat washer (2) and insert remaining armor through flat washer (3). Cut off the part of the armor that protrudes past the flat washers

(2)and (3).

Fold back armor		Flat washer
	(3)(2)		(1)

Flat washer (2)

Cut off armor that protrudes past flat washer.

6.Lead the signal cable through its cable gland and then into the chassis. Coat the threaded part of gland nut with sealant (supplied) and then tighten the nut.

TB801

PCB 03P9436

Cable gland for signal cable (RW-9600)

Antenna unit, front view

2-3