Furuno FAR-2157 installation manual Changing the cable entrance on control unit RCU-015/RCU-016

Changing the cable entrance on control unit RCU-015/RCU-016

To change the cable entrance from the side (default) to the bottom, modify the unit as shown below.

Screw M3X8

(torque: 10.78 Nm)

3. Pass cable thru this hole.

4. In here, clamp copper part of cable with cable clamp removed at step 1.

Bottom of unit

2. Pull out cable.

Cable clamp 03-163-7804

Screw M4X8

(torque: 1.47 Nm)

1.Remove cable clamp.

J522: Plug in here to connect RCU-016 in series with RCU-015.

Changing cable entrance on control unit RCU-015/RCU-016

1-14