Furuno FAR-2157 installation manual Monitor Unit, Mounting procedure, Flush mounting

1.2 Monitor Unit

The monitor unit is can flush mounted in a panel or mounted on a desktop (requires optional accessories).

The FAR-2157-BB is not equipped with a monitor unit. Procure a suitable monitor unit locally. Rec- ommended monitor: SXGA (1280×1024), aspect ratio 5:4.

For MU-190, see the applicable Operator’s Manual.

Mounting considerations

When selecting a mounting location, keep in mind the following points:

•Select a location where the screen can be viewed conveniently while facing the bow.

•Locate the unit out of direct sunlight and away from heat sources because of heat that can build up inside the cabinet.

•Locate the unit away from places subject to water splash and rain.

•Leave sufficient space on the sides and rear of the unit to facilitate maintenance, referring to the outline drawing for maintenance space.

•The monitor unit will give interference to a magnetic compass if it is placed too close to the com- pass. Observe the compass safe distances on page ii to prevent interference to the compass.

Mounting procedure

Flush mounting

Follow the procedure below to mount the monitor unit in a console.

1.Make a cutout in the mounting location referring to the outline drawing shown below.

2.Set the monitor unit to the hole and fix it with four self-tapping screws (6×30).

3.Attach panel hooks near the fixing holes (upper part). See next page. These are used to pull out the monitor unit from the panel for servicing.

4.Attach four panel covers to the fixing holes.

506	1	4-FIXING HOLES
	1	420		1	454
	296			296
				(79)
490		506	1	4-φ8
		534		FIXING HOLES		80
					30

Mounting dimensions for flush mounting the monitor unit

1-7