Furuno GP-1650WD installation manual Beacon receiver, Installation of Dgps beacon receiver

4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650W)

	J1
Cable assy.	J3
S.FL2-2LP0.7-D-WHT (175)

Notch

Beacon receiver

GR-7000A

Cable assy.

S.FL2-2LP0.7-D-WHT (121)

Beacon receiver

8.Connect cable assy. S.FL2-2LP0.7-D-WHT (121) (supplied) to J3 of the GR-7000A.

9.Close the lid of the GR-7000A.

10.Connect connector assy. PH6P-W-L240 to J2 of GR-7000A (Refer to the next page).

11.Fasten the GR-7000A (Beacon receiver) to the heat sink with four M3X10 screws (supplied) as shown in the figure below.

Pan-head Screw B

M3X10, 4 pcs.

Connect to

J8 on ANLG

Board.

S.FL2-2LPO.7-D-WHT (121)

Connect to

J2 on GN-8091.

Connect to

J106 on

MAIN Board.

Connect to J107 on MAIN Board

Cable Assy.

PH6P-W-L240

Cover of GR-7000A

Notch

Beacon Receiver Board

GR-7000A

GN-8091

Heat sink

Installation of DGPS beacon receiver

18