4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for
16.Fasten 8P connector cable and 6P connector cable by cable tie as shown in the figure below. Fasten mini pin coaxial cable by cable tie
Note: After connecting, pull up cable to remove slack so as not to pinch the cable between cover panel assembly.
Cable tie
ANLG board
PH8P
J106
J8
Mini pin coax. cable
PH6P
J107
Cable tie
Attaching cable tie
17.Reassemble the display unit.
Use new screws size 3X12 (supplied).
Nut, washer Torque: 1.37~1.57 N·m
Nut | Torque: 0.74~0.78 N·m |
|
Cover assembly
Screws X 6
Torque:
0.74~0.78 N·m
New screws X 6
Torque:
0.74~0.78 N·m
Remounting the cover
Note: When reattaching the cover, confirm the following parts are attached. Shield gasket, cover gasket (See the next page.)
Connector gasket (See the page 15.)
20
