Furuno GP-1650WD installation manual Wiring the Cable assembly, Attaching chassis assembly

4.INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650W)

12.Connect the cable assy. S.FL2-2LP0.7-D-WHT (121) of J3 to J2 of the GN-8091.

13.Pass the mini pin coaxial cable of J1 on the GR-7000A through the mini plug on the ANLG Board and connect it to J8 on the ANLG Board.

14.Mount the ANLG board on the heat sink.

GR-7000A

Mini pin coxial cable

Heat sink

Connect cable assy.

J1 of GN-8091 to J106 of MAIN board.

to J8 of ANLG board

to J106 of MAIN board

GN-8091

Cable tie

Clamp

Connect mini pin coaxial cable between J1 of GR-7000A and J8 of ANLG board.

			J2
J1	GR-7000A			Connect cable assy.
GN-8091
J2	J1	J3		J3 of GR-7000A to
				J2 of GN-8091.

to J107 of	Connect PH6P-W-L240 between J2 of
MAIN board	GR-7000A and J107 of MAIN board.

Wiring the Cable assembly

15.Mount chassis assembly on the panel assembly. Connect 8P connector and 6P connector to Main board as shown in the figure below.

Chassis assembly

A

Connector

A View	PH8P
	J106
	PH6P
	J107

Panel assembly

Attaching chassis assembly

19