Gaggenau Wok manual Connecting the appliance

8.2 Connecting the appliance Gas connection

8.2.1 Gas connection			The gas connection must be in a location that
			permits access to the shut-off valve and which, if
			applicable, is visible after opening the door of the
mm	16”		furniture item.
			By means of the included R 1/2” connection bracket
103	41/		(on the appliance end) with the affiliated washer,
			the appliance must be connected to a fixed
			connecting line or a gas safety hose to DIN 3383
			Part 1 that corresponds to the type concerned. An
			ambient temperature of 70 °K must not be
	40 mm		exceeded if the gas safety consists only partly of
	19/16”		metal. The permissible ambient temperature for a
		Seal	gas safety hose that consists completely of metal is
			115 °K.
	1/2”		If a flexible line is used, it must be laid in such a
Fig. 8			way that it cannot come into contact with moving
			parts of the kitchen element (e.g. drawer).
8.2.2 Electrical connection			Electrical connection
			Electrical connection (AC 110-127 V) is established
			by means of a connecting cable with an earthing
			contact plug connected to an earthed socket, which
			must also be accessible after installation of the gas
			hob.
	G		If, after installation of the gas hob, not all poles can
			be isolated from the mains by removing the plug,
			an isolating device with a contact gap of at least
			3 mm must be permanently installed. When estab-
	max 8”		lishing connections, make sure that the connecting
			lead cannot come into contact with hot parts of the
	(210 mm)
			gas hob or other hot parts.
(61024”mm)			Warning:
	mm)300-(200		This appliance is equipped with a three prong
			grounding plug for your protection against shock
			hazard and should be plugged directly into a pro-
			perly grounded receptacle. Do not cut or remove
			the grounding prong from this plug.
	8-12”	floor
	G : gas connection
Fig. 9		: electric socket
16