Warnings
1.Do not allow the flame to extend beyond the edge of the cooking utensil. This instruction is based on safety considerations.
2.Do not forget that the unit becomes hot when in use. Common sense is important. Just because the flame is out, it does not mean parts still cannot be hot.
3.This appliance shall not be used for space heating. This instruction is based on safety considerations.
4.Be sure to disconnect the electrical supply before disassembly of the appliance.
5.Keep the appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids.
6.Do not obstruct the flow of combustion and ventilation air.
7.Cabinets installed above the gas cooktop must have a minimum distance of 600 mm (24”).
8.The gas pressure regulator supplied with the appliance must be installed in line with the gas pipe.
9.The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of the system at test pressures in excess of 3,5 kPa (1/2 psig). The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 3,5 kPa (1/2 psig).
10.Important:
When using a very large pot, leave a gap of at least 50 mm (2") to avoid damaging any parts in counter top wood, plastic or other
Note:
To avoid jeopardising the electrical safety of the appliance, it is forbidden to use
Note:
The name plate is attached to the bottom of the unit and to the inside of the housing.
Only for installation in USA:
This installation must conform to local codes or, in absence of local codes, with the National Fuel Gas Code, ANSI Z
The installer must leave these instructions with the appliance, and the consumer should retain them for future reference. If an external electrical source is utilized, the appliance must be electrically grounded in accordance with local codes, with the National Electrical Code ANSI/NFPA
Only for installation in Canada:
This installation must conform local codes or, in the absence of local codes, with the current CAN/CGA- B 149 Installation Code. The installer must leave these Instructions with the appliance and the Consumer should retain them for future reference.
This appliance when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the current CSA Standard C
For mobile Housing and Recreational Vehicle installation must conform with the following:
CAN/CSA Z240 MH
CAN/CSA Z240 RV
Installation Requirement For Gas Burning Appliances And Equipment In Mobile Homes CSA Standard C 22:1 - Canadian Electrical Code Part 1 and /or local Codes.
3
