13)Install New Burner
∙Ensure that the bracket at the tip of the burner locks onto the bracket attached to the oven floor. No screws are necessary for this procedure.
∙The burner may not stand up perfectly by itself. The installation of the oven orifice later will correct this problem.
New burner and pilot assembly installed
14)Reinstall Both Front Shields
∙Install the right side shield first, guiding the various pieces of tubing and wire as shown in the below photograph. This setup will allow for an easier installation for the safety valve.
03/09/09 | P/N 4523367 | Page 13 |
