Step 3: Install the Intelliducer

After you have a hole drilled and prepared, install the bottom portion of the Intelliducer in the boat.

To install the bottom portion of the Intelliducer:

1.Apply a layer of marine sealant, at least 1/8 in. (4 mm) thick, on the inside of the outer lip and on the threads of the Intelliducer. Ensure the sealant extends at least 1/2 in. (12 mm) higher than the thickness of the hull, gasket, and locking ring.

2.From the outside of the boat, push the Intelliducer into the hole with a twisting motion.

Push firmly to squeeze out excess marine sealant.

3.From inside the boat, twist the Intelliducer so the “Keel” marking points toward the keel of the boat.

4.Place the gasket over the Intelliducer and press it against the hull.

5.Thread the locking ring on the Intelliducer until it tightens against the gasket. Hand tighten the locking ring—do not use tools—while ensuring that the “Keel” marking points toward the keel of the boat.

Threads Outer lip

Locking ring

Gasket

Keel direction indicator

6.From outside the boat, remove any excess marine sealant. This ensures water will pass smoothly over the Intelliducer.

7.Allow the sealant to dry completely as specified by the manufacturer of the sealant.

8.Test the installation for leaks.

caution: Do not leave the boat in the water unchecked for several days. Ensure there are no leaks before leaving the boat unattended in the water for more than an hour. Microscopic leaks may not be immediately apparent and could possibly sink your boat if left unattended.

•Place the boat in the water and immediately check for leaks in the installation of the Intelliducer.

 

• If no immediate leak is observed, check the installation

➌

 

every hour for the first 24 hours.

 

To install the top portion of the Intelliducer:

 

1.

Ensure the sealant has dried completely, and ensure the

➋

 

installation of the bottom portion does not leak.

2.

Connect the cable from the bottom portion of the

 

 

Intelliducer to the underside of the top portion ➊.

➊

3.

Place the top portion of the Intelliducer on the bottom

 

 

portion while ensuring that the top portion is flat against the

 

bottom portion ➋. Twist it clockwise—do not use tools— until it clicks to lock it in place ➌.

Thru-Hull Intelliducer Installation Instructions