Step 4 (NMEA 2000): Connect the Intelliducer to a NMEA 2000 Network

Follow these instructions to connect a NMEA 2000 Thru-Hull Intelliducer. If you have a NMEA 0183 Thru-Hull Intelliducer, see Step 4 (NMEA 0183).

The Intelliducer is packaged with a NMEA 2000 T-connector and a NMEA 2000 drop cable. Use these two components to connect the Intelliducer to your existing NMEA 2000 network. If you do not have an existing NMEA 2000 network, you will need to install a NMEA 2000 network on your boat. For more information on NMEA 2000, visit www.garmin.com.

To connect the Transom Mount Intelliducer to your existing NMEA 2000 network:

1.Determine an appropriate location to connect the Intelliducer to your existing NMEA 2000 backbone.

2.Disconnect one side of a NMEA 2000 T-connector, or disconnect a terminator from the backbone nearest to the location where you want to connect the Intelliducer.

If you need to extend the NMEA 2000 backbone, connect an appropriate NMEA 2000 backbone extension cable (not included) to the T-connector or terminator you disconnected.

3.Connect the included T-connector for the Intelliducer in the NMEA 2000 backbone.

4.Route the NMEA 2000 drop cable to the Intelliducer and to the bottom of the T-connector you added to your NMEA 2000 network.

Existing NMEA 2000 network

(not included)

T-connector

(included)

Drop cable (included)

Additional

NMEA 2000

device

(not included)

Thru-Hull Intelliducer

Connecting the Intelliducer to a NMEA 2000 Network

Thru-Hull Intelliducer Installation Instructions