PS Engineering
PAV80
Installation and Operator’s Manual
Section III OPERATION
GENERAL INFORMATION
3.1SCOPE
This section describes the operation of the PAV80
Figure 3-1 Front Panel Controls
3.2Operating Controls
The
If a DVD is inserted, the unit will wait for menu instructions.
3.2.1Power/Volume Control (1)
The PAV80 system is turned on and off by pushing the volume (left hand) knob. A short press will acti- vate, and deactivate the unit.
The left knob is also the volume control, with 30 steps. The knob controls the volume of the primary out- put. To modify the volume of the SECONDARY output, press the volume knob for more than 2 seconds. The secondary output indication (right side of window) will blink, and you can now adjust the secondary output volume.
If the knob is not active for more than 5 seconds, the volume control reverts to the primary state.
The four push buttons are used to perform different functions. The function will depend on the mode of the primary audio output, as displayed on the left side of the display (P).
3.2.2▲ Stop/Eject Button (2)
In disc mode, the Stop/Eject button will stop the disc. Hold for 3 seconds to eject the disc. In AM/FM mode, this will scan up to the next strong radio station.
3.2.3► Play/Pause Button (3)
In disc mode, pressing the play/pause button momentarily will pause the player. Press again to resume play.
In AM/FM mode, this will scan down to the next strong radio station.
Page | Rev. 5 Feb. 2004 |