Garmin PAV80 operation manual Panel Opening, Connector Assembly

PS Engineering

PAV80 Series IFE System

Installation and Operator’s Manual

Panel Opening

Saw and file used to remove existing instrument panel from this location

Figure 2-3 Completed panel opening (Typical)

Figure 2-4 Completed panel installation

2.3.4Connector Assembly

The unit connector mates directly with the circuit boards in the PAV80. The connector (part number 120- 425-4402 is a Molex crimp-type, and requires the use of a Molex hand crimp tool, EDP P/N 11-01-0203, CR6115B (or equiv.). The connector is mounted to the unit tray with 2 ea. #4-40 screws, from the inside of the tray.

After installing the connector, install the connector shield on the back of the tray with 2 ea #4-40 screws, washers and nuts.

Ensure that proper strain relief and chafing precautions are made during wiring and installation of the tray and shield.

200-800-0101 Page 2-3 Rev 2 Sept. 2003