Installing Accessories
To connect the fan wires:
1.Remove the wiring box cover by removing the two screws on the underside of the wiring box. Removing the wiring box cover will expose the screws that secure the front panel cover.
2.Remove the front panel cover by removing the two screws on the underside of the front panel.
3.Plug the wire leads from the fan assembly into the pin connectors on the DC circuit board. The pins are located to the left of the LCD below the ground fault protection fuse.
4.Replace the front panel cover using the screws removed in step 2, with the wire leads passing through the notch at the top of the cover, ensuring that the wires are not pinched.
5.Replace the wiring box cover using the screws removed in step 1.
Fan connectors
