Mounting the Inverter
Mounting on Wallboard, Siding or Concrete
To mount the GT Inverter to wallboard, siding, or concrete:
1.Locate the area where the GT Inverter is to be installed.
2.Install backing support material if required. See Figure
At least 2 screws | 30 cm (12") |
with washers to | |
secure bracket |
|
to plywood |
|
110 cm (43") | 110 cm (43") |
Ground / Floor | Ground / Floor |
Single GT Inverter | Dual GT Inverters |
Figure 2-10 Installing the Mounting Bracket using Plywood Support
3.Using a level, place the mounting bracket against the wall surface at least 110 cm (43 inches) from the ground. See Table
4.Mark the location for mounting screws if using a wall stud for support. At least four mounting screws and anchors are needed for concrete installations or wallboard installations where no wall studs are available for support.
For multiple inverters mounted in parallel, the brackets should be mounted 30 cm (12 inches) apart. Inverters mounted less than 30 cm (12 inches) apart may not achieve full rated power.
5.Remove the bracket and drill the holes using an appropriately sized drill bit. Drill appropriately sized holes for screws or anchors.
6.Secure the bracket to the supporting surface using at least two screws and washers.
