Replacing the Wiring Box Cover
Replacing the Wiring Box Cover
After performing the voltage checks, replace all covers that were removed during installation and startup.
WARNING: Shock hazard
Before reattaching covers, turn OFF the breaker switches in the main utility service panel and the AC/DC Disconnect switch on the GT Inverter.
If the front panel cover was removed from the GT Inverter, then it must be replaced before the wiring box cover is replaced.
To replace the front panel cover:
1.Place the cover in position on the front panel, being careful not to pinch any wires. The fan wires should pass through the notch in the upper edge of the front panel cover.
2.Ensure that the two screw holes in the bottom of the front panel cover are aligned with the corresponding holes in the bottom of the inverter (not the wiring box).
3.Replace the two screws removed when the cover was removed (see “Installing the Fan Assembly” on page
To replace the wiring box cover:
1.Place the cover in position on the wiring box, being careful not to pinch any wires in the wiring box.
2.Ensure that the two screw holes in the bottom of the wiring box cover are aligned with the corresponding holes in the bottom of the wiring box.
3.Replace the two screws removed when the cover was removed (see “Accessing the Wiring Terminals” on page
