Safety
Regulatory Compliance
The GT Inverter has complete
•UL 1741 – Standard for Inverters, Converters, and Controllers for Use in Independent Power Systems
•CSA C22.2 No.
•IEEE C62.41 Recommended Practice on Surge Voltages in
To locate the firmware version number
The firmware version number for the protection processor is visible on a screen that appears when the unit starts up or is powered up after switching the AC/DC Disconnect switch to “on.” The screen reads:
TheFlash=01numberROM=01appearing.01.01after “ROM” is the firmware version number for the protection processor.
FCC Information to the User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular instal ation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
viii |
