Xantrex Technology GT3.0 To attach the fan assembly to the inverter, 12Attaching the fan assembly

Installation

To attach the fan assembly to the inverter:

1.Using a Phillips screwdriver, remove the four panhead screws and washers from the front panel of the inverter (two screws on each side), immediately below the heat sink (see Figure 2-12).

2.Place the fan bracket with screw holes overlapping the screw holes on the inverter. The fans should be facing up, on the upper side of the fan bracket.

3.Replace the four panhead screws and washers removed in step 1.

Figure 2-12Attaching the fan assembly

2–24 975-0131-01-01