Monitoring the Inverter
52975-0131-01-01
Monitoring the Front Panel Display
During startup During startup, the inverters front panel LCD (see Figure5-1) shows the first
three screens described in Table 5-1, Startup Screens on GT Inverter Front Panel
Display on page 53.
During waiting
period When the five-minute, five-second (305 seconds) protection timer begins, the
inverter displays Reconnecting in sss se conds (see Table5-10, Special
Message Screens on page 58).
During operation When the protection timer stops, the GT Inverter begins selling power, indicated
by the power output reading in the display (see Table5-2, Normal Operation
Default Screen on page 54).
When the inverter is
offline or there is
fault condition
When the GT Inverter is offline (e.g., at night) or a fault condition has been
detected, the LCD shows a mes sage screen to indicate that state. Th e specific fault
condition will be identified. See Table 5-5, Offline Mode Default Display on
page 55 and Table5-8, Fault Message Screens on page 57.
Viewing more
information Additional screens of information about the performance of the GT Inverter can be
displayed by tapping the Xantrex logo on the inverter front panel. This ca uses the
LCD to cycle through a series of information sc reen s in N orma l Operation,
Offline or Fault modes. These are described in detail in the following section,
Front Panel Display Screens and What They M ean.
Important:
The values in the front panel LCD are not user adjustable.
Figure 5-1
Front Panel LCD Location
Front panel LCD Tap Xantrex logo for
backlight/status screens.