Installation

Mounting the Inverter on the Bracket

Mounting a Single Inverter

To mount the inverter on the mounting bracket:

1.Place the GT Inverter’s mounting hooks, located on the back of the enclosure, over the bracket and ensure the inverter is seated properly, as shown in Figure 2-11.

2.After the unit is correctly seated on the bracket hooks, locate the mounting slots in the flange below the wiring box and mark the location on the wall for securing screws.

3.Remove the inverter and drill pilot holes in the wallboard or siding for the securing screws.

4.Reinstall the GT Inverter on the bracket and secure the bottom of the unit with appropriate screws or anchors, and tighten.

Slide the mounting hooks on the inverter over the hooks on the mounting bracket.

flange with mounting slots

Ensure the inverter is seated properly on the mounting bracket

Figure 2-11Proper Placement of the Inverter on the Mounting Bracket

2–22

975-0131-01-01

Page 50
Image 50
Xantrex Technology GT3.0 owner manual Mounting the Inverter on the Bracket, Mounting a Single Inverter