Garmin PAV80 operation manual Factory Avionics Location, Mounting Rack Installation

PS Engineering

PAV80 Series IFE System

Installation and Operator’s Manual

2.3.3Mounting Rack Installation

Remove the unit from the mounting tray by unscrewing the 3/32" hex-head screw that is near the left edge of the unit. Carefully slide the unit free of the tray. Set the unit aside in a safe location until needed. Install the tray using six FHP 6-32 x ½" screws. The unit must be supported at front and rear of the mounting tray. See Appendix B.

6.31”

2.00”

Figure 2-1 Typical Tray Installation Location

The tray mounting can be made in any area that exists for adding additional avionics. Instrument panel mounting is accomplished in accordance with AC 43.13-2A, Chapter 2.

Existing Structure (from behind

panel)

Avionics Mounting Rails

Factory Avionics Location

Factory Avionics Mounting Rails

Center Avionics Stack

Existing Transponder

Figure 2-2 Avionics Mounting Rails (Typical)

200-800-0101 Page 2-2 Rev 2 Sept. 2003