Table of Setup Codes and Parameters
| FINE TUNING CODES |
| |
|
|
|
|
Description | Code | Values of the Parameters | Factory |
|
|
| Defaults |
Acceleration Limiter | 5 | 1 lowest accel, 100 Highest accel | 39 |
Code 5: This parameter limits the aggressiveness of the autopilot controlled turns. Turn it up to allow higher rate turns and down to limit the turn rate.
Seastate Filtering | 1 | 1 least responsive steering, 4 most responsive | 4 |
|
| steering |
|
Code 1: Seastate adjustments, toward least responsive, slow the heading response down and reduce rudder activity. Most of the time you will want to run with this parameter all the way at the top of its range. In choppy or trailing seas at low speeds, reducing this parameter will save wear and tear on your system.
Low Speed Rudder Gain | 27 | 1 lowest gain 97 highest gain | 39 |
Low Speed Counter Rudder Gain | 37 | 1 lowest gain, 97 highest gain | 72 |
High Speed Rudder Gain | 29 | 1 lowest gain 97 highest | 39 |
High Speed Counter Rudder Gain | 39 | 1 lowest gain, 97 highest gain | 72 |
Following Seas Switch | 159 | [Up Arrow] on, [Down Arrow] off | off |
Code 159: Turning this parameter on may increase stability in severe trailing seas. |
| ||
Turn Stop Adjust | 268 | 1 least adjustment, 40 most adjustment | 1 |
Code 268: At planing speed and for large turn angles; if your boat tends to turn further than you programmed for, (like | |||
50 degrees when you programmed 45 degrees) and then slowly recovers to the turn angle you expected, turning this parameter up may solve the problem.
|
| AUTOMATED SETUP CODES |
|
|
|
Description | Code |
|
Calibrate Compass | 47 | Hold Down [Select Load] Button, Press and Release Deckmount Button |
|
| to Start Calibration Process |
Autotune | 58 | Hold Down [Select Load] Button, Press and Release Deckmount Button |
|
| to Start Tuning Process. |
|
| Code 57: Code 57 lets you select an alternate autotune. You may want to try this |
|
| if the normal tune didn’t work. After selecting the alternate by selecting code 57 and |
|
| pressing the Down Arrow button (so that the Down Arrow LED is lit), go back to code |
|
| 58 to initiate the autotuner. |
Load Factory Compass | 247 | Hold down [Select Load] button, Press and Release Deckmount Button |
|
| to Reload Factory Pilot Settings |
Load Factory Pilot | 248 | Hold Down [Select Load] Button, press and release Deckmount Button |
|
| to Reload Factory Pilot Settings |
Show Software Version | 369 | Hold Down [Select Load] Button, version=blink code/100 |
|
|
|
38
