GarrettCom manual Connecting the Console Terminal to Magnum 6K25 Management, Console DB-9 Port

Magnum 6K25 Managed Fiber Switch Installation and User Guide (04/06)

Step 3. Remove 6KPM Card

Carefully and gently pull

out the daughter board from the latching connectors, using both hands, gripping the board near the latch-up connectors as shown in Fig. 3.5.3b . If the now empty slot is to remain unused, be sure to install

a6KPM-BLNK face plate cover.

Figure 3.5.3b: Removing a 6KPM Card

If another 6KPM card is replacing the one that has been removed, follow the steps as described for installing a 6KPM card discussed in Section 3.5.1.

3.6Connecting the Console Terminal to Magnum 6K25 (Management)

Use a DB-9 “null modem” cable to connect the Magnum6K25 Console Port (the RS-232 port on the 6K25 Switch) to the your PC, so that your PC becomes the 6K25’s Console Terminal.

Note: The DB-9 cable does not include with the 6K25 unit package.

Console (DB-9)

Port

CONSOLE

PORT

O

OF

Rear View of Magnum 6K25, (Typical Console Port is on the Rear of Reverse 6K25 Models)

Note: For detail description of Managed Network Software (MNS-6K) and Magnum 6K25 Switch configuration for Network Management, please refer to Magnum 6K25 Software Manual available on GarrettCom‘s FTP site. Detail info. about the MNS is available on 2.2.9 ( see page no. 13) of this manual.

www . GarrettCom . com

34