25
Installing the autoloader into a cabinet
www.gateway.com
Connecting the cables
To connect the cables to the autoloader:
1Choose the appropriate SCSI cable to use (two SCSI cables are supplie d with
your autoloader).
■If you are connecting the autoloader to a device that uses a 68-pin
HDC connector, use the cable that has HDC connectors on both ends.
- OR -
■If you are connecting the autoloader to a device that uses a
high-density VHDC connector, use the cable that has the VHDC
connector on one end and the HDC connector on the other.
2Make sure that the autoloader is turned off (press the right side of the power
switch).
3Connect the SCSI cable and the terminator. For more information about
the SCSI interface, see “SCSI interface” on page52.
aConnect one end of the SCSI cable to one of the SCSI connectors on
the back of the autoloader.
bConnect the other end of the SCSI cable to the SCSI connector on
the SCSI host bus adapter or on the previous device of the SCSI bus.
cIf this is the last device in the SCSI chain, connect the SCSI terminator
to the remaining SCSI connector on the back of the autoloader.
4Connect one end of the power cord to the AC outlet on the back of the
autoloader.
SCSI connectors Fan AC outlet