
CHAPTER 4: Installing Components
Caution
Pressing or pulling on any components on the backplane could result in damage to the backplane.
Caution
Make sure that you do not pinch, bind, or damage any cables as you install the backplane.
8Holding the new backplane by the edges only, align it with the locking tabs on the chassis, then place it on the locking tabs and slide it to the left until it stops.
9Tighten the thumbscrew to secure the backplane.
10Reconnect all cables to the backplane.
11Replace the fan board and system fans by following the instructions in “Replacing system fans” on page 41.
12Follow the instructions in “Closing the server case” on page 30.
13Reinstall the
14Replace the bezel by snapping it into place on the front of the server.
Replacing the ROMB battery pack for the mezzanine RAID card
Warning
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of or recycle used batteries by taking them to a hazardous waste facility. Follow all local regulations for correct battery disposal.
To replace the ROMB battery pack for the mezzanine RAID card:
1Follow the instructions in “Preventing static electricity discharge” on page 28. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.
2 Follow the instructions in “Opening the server case” on page 29.
50