
www.gateway.com
6Remove the heat sinks and processors by following the instructions in “Replacing or adding a processor” on page 43.
7Disconnect all cables from the system board, noting their locations and orientation. (You will reconnect the cables after you install the new board.)
8Loosen the two thumbscrews (1) that secure the system board to the server.
22
22
2
1 | 2 |
2
9Slide the system board toward the back of the server until it is free of the eight retaining standoffs (2), then lift the board from the chassis.
10Place the old system board in a
11Insert the new system board into the chassis, aligned with the eight retaining standoffs, then slide the board toward the front of the case so the board is held by the standoffs.
12Tighten the two system board thumbscrews you loosened in Step 8.
13Connect the cables you removed in Step 7
14Install the memory by following the instructions in “Installing memory” on page 36.
15Install the processor and heatsink by following the instructions in “Replacing or adding a processor” on page 43.
55