
www.gateway.com
9Press the tab (8) holding the riser card in the riser card assembly, then push the riser card in the direction shown (9) to unlock and remove it from the standoffs.
Standoff
10Insert the new riser card into the riser card assembly, then push it toward the back of the assembly. It should snap into place.
11Insert the new PCI card into the riser card, making sure any connectors extend through the slot at the back of the assembly and that the card is fully seated in the riser card.
12Close the release lever (see Step 6) and the card guide tab.
13Position the PCI riser card assembly (1) over the PCI socket on the server board, then press the PCI riser card assembly into the PCI socket until it clicks into place.
14Follow the instructions in “Closing the server case” on page 27.
15See the card’s documentation for software installation instructions.
37