GBC 1264WF/1244WF | Operation Manual |
|
|
Webbing Thermal Film Using Threading Card
CAUTION: The laminator rollers will be hot and can burn you. For pressure sensitive film (PSA), refer to the section titled
WEBBING: USING FILM THREADING CARD FOR PSA FILM.
1. Turn the Main Power ON | /OFF | to On. |
2.Set top and bottom temperature with regards to the film type used.
3.Ensure no brake tension is applied to the film shafts.
4.Pull the top roll film down under the upper idler bar and allow to drape over the top heat roller (Fig. 3)
5.Pull the lower film behind the lower idler bar, Lower the table Pull Film up towards the film draped over the top heat roller and adhere the Lower Film to the upper Film (Fig. 4).
6.Pivot the table back to its feeding position while ensuring the threading card is on top of the feed table (Fig. 5).
7.Use a threading card to push the two materials into the heat roller nip.
8.Lower the main roller to initial contact with the threading card.
9.Ensure forward is selected for Motor direction and Press the Foot Switch
10.From the rear of the machine, guide the web over the chill idler, if installed, and through the pull rollers.
11.Once the web has entered the pull roller nip, lower the pull roller nip. Adjust unwind film tension; use as little tension as possible to get smooth output.
12.Once the threading card has completely exited the pull rollers, press the stop button.
13.Now refer to the section entitled START LAMINATING.
Fig.3
THERMAL
LAMINATE
Fig. 4
THERMAL
LAMINATE
THERMAL
LAMINATE
Fig. 5
THERMAL
LAMINATE
THERMAL
LAMINATE
© 200 6 General Binding Corporation | Page 27 |
