GBC operation manual GBC 1264WF/1244WF Loading Film

GBC 1264WF/1244WF Operation Manual

Loading Film Continued

The core chucks need to be adjusted to match the width of the film that is going to be loaded on the laminator. To do this, be gin by removing the rubber o-rings.

Then use the included hex tool to loosen the setscrews in the core chucks. Note: Do not remove the setscrews; they only need to be loosened.

Make the necessary adjustments to the upper roll of laminate to center it to the Main Rollers.

Slide the Core Chucks into place and gently tighten the setscrews to secure the Core Chuck. The rubber O-Rings can be replaced to keep the film from moving off center.

Make the necessary adjustments to the lower roll of laminate to match up with the upper. Lock the Core Chucks into position and replace the O-Rings.

© 200 6 General Binding Corporation Page 23