GBC 1264WF/1244WF | Operation Manual |
Fig. 6
REWIND TUBE
PSA
Film
Mount
Adhesive
Fig. 7
PSA
Film
CHILLED ROLLER
HEAT ROLLER
Mount
Adhesive
Fig.8
Webbing PSA Film/Mount Adhesive Using Threading Card
The laminator should be cool to the touch before Proceeding.
1. Turn the Power ON /OFF | to On |
2.Load the rolls of film as illustrated in (Fig. 6). Ensure no brake tension is applied to the film shafts.
3.Pull the top roll of film down under the idler bar and up to the upper front rewind tube.
4.Place one piece of masking tape in the center of the film and secure to the rewind tube.
5.Make two full wraps around the rewind tube, and then score the laminate without cutting the release liner. Pull the laminate down allowing it to drape over the upper roller (Fig. 6).
6.Pull the mount adhesive up towards the film draped over the upper heat roller (Fig.7).
7.Stick the mount adhesive to the exposed adhesive of the upper role.
8.Insert the table back to its feeding position while ensuring the threading card is on top of the feed table (Fig. 8).
9.Use a threading card to push the two materials through the heat roller nip
10.Lower the main heated roller to bring the main roller into initial contact with the threading card. Ensure front is selected and press the foot switch.
11.From the rear of the machine, guide the web over the chill idler, if installed, and through the pull rollers. Once the web has entered the pull roller nip, close the pull roller nip –
12.Press the stop button when the threading card has completely exited the pull rollers and adjusts the film web tension using as little tension as possible.
13.Now refer to the section titled START LAMINATING.
© 200 6 General Binding Corporation | Page 28 |
