GCC Printers Elite 12ppm

C-2

GCC strongly recommends that you use a grounding wrist strap. You can buy one fromthe same place that you bought your SIMMs. If you do not have a grounding wrist strap,touch the perforated metal chassis of the printer (see step 9 following).Installing the RAM into the Elite12ppm

1. Switch off the printer. Do not

unplug the power cord from

the AC outlet.

2. Unplug the interface cables

from the back of the printer.

3. If necessary, move the printer so

that you have clear access to its

left side.

4. Remove the paper tray.

5. Open the top cover by pressing the

release button on the top right of the printer.

6. You need to remove the side cover. Unscrew

the two thumbscrews at the rear of the

printer (labelled “A” in the bottom picture).

If these are tight, you may need to use a #2

Phillips screwdriver.

7. Reach inside the case. Pull the

edge of the cover (B) toward

you, then move the cover

away from the rest of the

printer to prevent it from

latching again.

8. Place both hands on the top

of the side cover (C). Lift the

edge of the cover next to

the top cover; this unlatches

the cover, and you should

be able to slide the cover

away from the printer.