D-3
8. Replace the 500-sheet and the 250-sheet paper trays.
9. If necessary, move the printer to the location where it will be kept. There are
two finger grips, one on either side of the sheet feeder.
10. Reconnect the power and interface cables.
11. Configure the software on each computer that will use the printer.
Using the 500-sheet paper tray and the envelope paper tray
The sheet feeder can hold either the 500-sheet paper tray or the envelope tray. These slide
into the sheet feeder in the same way as the 250-sheet paper tray slides into the printer.
Loading the 500-sheet paper tray
Loading the 500-sheet paper tray is similar to loading the 250-sheet paper tray, but you
adjust for different paper sizes in a different way.
1. Remove the paper tray from the feeder.
2. If you need to adjust the paper size guides, follow the next four steps. If not, go
to step 6.
3. Turn the paper tray so that the front is away from you. The length guide has
two indentations at left and right. Put your thumb in one and push up gently.
When this releases that side, push up the other side.
4. Slide the guide forward or backward so that the colored tabs on the base of the
paper tray align with the position for the paper size you’ll be using.
5. Press down on the guide to lock it into place. Turn the paper tray around so
that the front is toward you.
6. Squeeze the width guide lever toward its brace, and then pull the guide lever
to the right.